AeroScout Tail Dragger Conversion Kit - AKA the MonsterScout / TimberScout Mod - Landing Gear Conversion Mod

Can the AeroScout be a bush plane? With the KIN Additive landing gear conversion kit the answer is YES! Utilizing the provided step by step guide and some minimally invasive surgery (provided by you) you can turn the AeroScout into a MonsterScout (TimberScout) in ~20 minutes!

*the pictured wheels are an optional add-on*

Suggest Wheel Sets and Use Case:

-Stock 3" Wheels

-Asphalt/smooth dirt

-Economical and lightweight

-20 grams a set

-Next-Gen Airless Wheels 4.25"

-Asphalt, short and long grass, smooth or rugged dirt

-Shock absorption and dampening effects from the crushable tire.

-56 grams a set

-Timber Foam Wheels 4.25"

-Asphalt, short and long grass, smooth or rugged dirt

-Traditional look

-Modification of wheels required (drilling the rim to 4.25-5mm)

-60 grams a set

Do you have the "original fuselage" or the "new fuselage"??

If there is no hole at the bottom of the rudder/tail you have the original fuselage. The original fuselages do not have an access hole to the rudders control shaft. Because of this it is suggested to purchase a "Wing Tip/Tail Skid" from Du-Bro to protect the tail or you can purchase the water rudder "HZ3821" from Horizon Hobby and then follow the instructions from the floats manual. Google "HBZ3811 floats manual" and go to page #6 to see the process of adding access to the rudder control.

Included in The Conversion Kit:

x1 Carbon Fiber reinforced PETG landing gear

x1 front internal mounting plate

x1 rear internal mounting plate

x1 Tail Wheel

x1 drilling guide template

x1 installation hardware set

Tools Needed:

-Needle nose pliers

-2.0 hex driver

-1.5 hex driver

-1.3 hex driver

-Small Phillips driver

-3/8" drill

-1/4" drill

-1/8" drill

-Razor blade

-CA glue